MINI-LINK TN networks rely on plug-in units inside an Access Node Magazine (AMM). Managing these slots is crucial during hardware replacements.
Some advanced CLI commands are hidden by default to prevent accidental misconfiguration. To view these, you must enter the cliunlock command in Privileged EXEC mode before using them.
admin> alarms ls
: Generates a local backup archive of the system state.
admin> services create name=Backhaul_RAN admin> services add-ce name=Backhaul_RAN ce-id=1 port=1/2 vlan=100 admin> services add-radio-flow name=Backhaul_RAN radio-flow-id=5 ericsson mini link cli commands
Lists all physical hardware modules, including pluggable units (MMUs, LTUs), serial numbers, and hardware revisions. show licensed-features Use code with caution.
: Returns to the previous mode or closes the CLI session. MINI-LINK TN networks rely on plug-in units inside
MINI-LINK-001> enable MINI-LINK-001# configure terminal MINI-LINK-001(config)# hostname Site22_ML MINI-LINK-001(config)# interface eth0 MINI-LINK-001(config-if)# ip address 172.16.1.10/24 MINI-LINK-001(config-if)# no shutdown MINI-LINK-001(config-if)# exit MINI-LINK-001(config)# interface radio0 MINI-LINK-001(config-if-radio)# frequency 18000.000 MINI-LINK-001(config-if-radio)# tx-power 20 MINI-LINK-001(config-if-radio)# modulation adaptive 256qam MINI-LINK-001(config-if-radio)# exit MINI-LINK-001(config)# write memory MINI-LINK-001(config)# end MINI-LINK-001# reboot
: Always run a configuration export before updating software or changing routing/VLAN profiles. To view these, you must enter the cliunlock