Listen closely for a mechanical clicking sound inside the door when you enter the code.
Very easy. It came with the mounting bracket already attached. I simply unscrewed the old unit, disconnected the wire harness, plugged this new one in, and screwed it back on. Total time was under 5 minutes.
: Users often prefer swapping the entire bracket rather than just the faceplate to ensure a "tighter" and more secure fit. Amazon.com.au Key Replacement Specifications
Never attempt to replace a keypad while the safe door is locked shut. If you are locked out, you must use your safe's emergency bypass key (if equipped) to open the door manually before proceeding with the electronic replacement. 2. Remove the Old Keypad Housing intellok safe keypad replacement verified
Before replacing the keypad, ensure the 9V battery is brand new, as low voltage is the #1 cause of failure.
If your safe door is currently , replacing the keypad is a straightforward, 10-minute DIY project.
If it is a slide-lock mechanism, press firmly up on the outer housing to unseat it from the mounting collar. Step 2: Disconnect the Ribbon Cable Listen closely for a mechanical clicking sound inside
This guide provides a verified, step-by-step approach to choosing and installing a replacement keypad for your Intellok safe. Signs You Need a Keypad Replacement
Locate the plastic clip connecting the wire harness to the back of the keypad circuit board.
Individual numbers fail to register when pressed, or the entire keypad remains dark. I simply unscrewed the old unit, disconnected the
Look at the very bottom edge of the keypad ring. If there is a tiny screw, remove it.
Take your new verified replacement keypad and firmly press the wire harness connector into the receiving port on the back of the board. It will only fit in one orientation. You should hear a distinct click confirming it is locked in place. Step 5: Mount and Test (With the Door OPEN)
It may be time to replace your IntelliK safe keypad.