Sup0108 A Deployment Or Update Operation Is Already In Progress Best !new! -

: Ensure your iDRAC is running the latest version, as Dell has released fixes (e.g., version 7.20.10.50) specifically to address job-start failures. RACADM commands for your server generation to clear the queue? iDRAC 9 Firmware Upgrade issue - Server Fault

Encountering a SUP0108: A deployment or update operation is already in progress error can be a momentary setback, but it is almost always solvable. By understanding that it's a lock flagging a busy process, you can move from frustration to a systematic fix. Start with the easiest steps: wait, then restart the iDRAC. When the problem persists, confidently use the RACADM command line ( racadm jobqueue delete -i JID_CLEARALL_FORCE ) to break the deadlock and clear the path for your intended firmware deployment. By following these steps, you'll minimize downtime and ensure your server management stays on track.

: Newer iDRAC9/10 firmware versions often contain fixes for these reporting bugs where the "in progress" message persists longer than it should.

As of the latest updates, Microsoft has noted that on the "Extension Installation Status" page within some deployment interfaces, there is for an update that is already in progress. Therefore, the methods described above—restarting services or clearing the queue via command line—are your primary avenues for resolution. : Ensure your iDRAC is running the latest

The Dell PowerEdge Event and Error Message (EEM) Guide classifies SUP0108 as a system lock warning. This happens under three specific technical conditions:

docker service ps <service_name>

The Dell iDRAC error indicates that the Integrated Dell Remote Access Controller (iDRAC) Lifecycle Controller communication channel is locked. This issue occurs when a previous firmware update, operating system deployment, or driver mount operation fails, times out, or gets stuck in the system's job queue. By understanding that it's a lock flagging a

Before deleting logs or restarting services, confirm if a legitimate deployment is running.

Follow these troubleshooting procedures, ordered from the least invasive method to the most comprehensive. Method 1: Clear the iDRAC Job Queue and Reset

The SUP0108 error is a software update point (SUP) error that occurs when a deployment or update operation is attempted while another operation is still in progress. This error can happen in various scenarios, such as: By following these steps, you'll minimize downtime and

To resolve this error and proceed with your operation, follow these prioritized actions: Reset the iDRAC

: Do not perform firmware updates when the server's CPU is under heavy utilization, as this can impact internal fan speeds and communication with the Lifecycle Controller.