The LED will stay solid Red, indicating you are successfully in programming mode. To exit programming mode at any time, simply press * . Changing the Master Code

Standard 125 kHz (EM or compatible ID cards/fobs). Reading Distance: 3 to 6 cm. Operating Voltage: 12V DC ± 10%. Current Draw: < 60mA. Lock Output Load: Max 3A. Bell Output Load: Max 50mA.

Connect the wire of the V2000-C to the Power Supply +12V.

If you need to configure a specific accessory with your V2000-C, let me know you are installing (e.g., Maglock, Electric Strike), if you are adding an external exit button , or if you need help with a specific programming error code .

and operates primarily with 125KHz EM standard cards or 4-digit PIN codes. Key Specifications 1,000 effective cards/users. Operating Voltage: 12VDC ± 10%. Access Modes: Card only, Card + PIN, or PIN only. Dimensions: 119mm x 76mm x 21mm. www.goldbridgesz.com Programming Instructions To perform any programming, you must first enter the Program Mode Enter Program Mode: + [Master Code] + (Default Master Code is typically Exit Program Mode: Command (while in Program Mode) Add a Card + [Read Card] or [Input Card Number] + Delete a Card + [Input Card Number/ID] + Change Master Code + [New Code] + + [New Code] + Set Door Open Time + [TT (00-99 seconds)] + Delete All Users (Use with caution!) Access Mode Settings You can configure how users gain entry: МікроАмпер Card OR Password (Default): Card AND Password: Password Only: Maintenance & Troubleshooting Factory Reset:

If you forget your management password or wish to reset the system to its factory default state, follow these initialization steps.

Comprehensive User Manual & Guide for the V2000-c RFID Access Control Keypad The V2000-c RFID Access Control Keypad

End of the V2000-c RFID Access Control User Manual.

Connect the wire of the V2000-C to the Power Supply +12V.

The system is in normal standby mode or the door lock is currently released. Red LED: The system is in programming mode.