Wittmann Tempro Plus D 360 Manual Exclusive Jun 2026

: Includes automatic filling, constant pressure monitoring, maximum temperature monitoring, and sensor break detection.

Shut down the unit, allow it to cool completely below 120°F (49°C), bleed the pressure, and clean the internal water strainers. Debris blocks flow and damages the pump.

Wittmann technical publications are indexed by a specific part number (e.g., M146.0006 for older models). Search for that number, not just the model name. The serial number ( S/N: 306344 for a 2017 model in one listing) is also a key identifier for Wittmann service technicians. wittmann tempro plus d 360 manual exclusive

Based on technical guidance from the Wittmann Group , key operational procedures include:

Sharing these details will help me provide the exact technical solution you need. Share public link Wittmann technical publications are indexed by a specific

Operational Analysis and Safety Compliance of the Wittmann Tempro Plus D 360 with “Manual Exclusive” Control Mode

Always use synthetic oil with a flash point and boiling point well above the 360°C threshold. Operating near or above an oil’s flash point presents a severe fire hazard. 2. Installation and Pre-Operational Setup Based on technical guidance from the Wittmann Group

To avoid damage, never disconnect power while the heater is active. Users must initiate a "Cool Down" sequence (indicated by a snowflake icon) to lower the internal temperature before the unit enters an "Off" state.

Do you need help finding the for this unit?

The "360" in the model name signifies the heating capacity suited for medium to large molds.