Connect your battery charger to the terminals and the battery itself to the OUT terminals.
specifies a voltage calibration function to sync the module with the actual battery state. 5. Safety and Installation Best Practices According to documentation from AliExpress retailers , proper configuration is essential: Reverse Polarity:
To change the target temperature or calibration settings, follow this standard procedure: xycd60 manual
Disclaimer: This manual is a reconstruction based on standard operating procedures for the XYCD series of temperature controllers. The manufacturer may update firmware or hardware without notice. Consult the specific paper insert included with your product for exact terminal diagrams.
Over-discharge protection, Overcharge protection. Modes: Charging Mode ( ) and Discharging Mode ( Connect your battery charger to the terminals and
Protects batteries from damage by disconnecting the load when voltage hits the "dn" floor.
| Code | Function | Description | Range/Default | | :--- | :--- | :--- | :--- | | | Heating / Cooling Mode | Sets the relay to activate on temperature drop (Heating) or rise (Cooling). | H (Heating) / C (Cooling) | | P1 | Hysteresis (Dead Band) | The difference between stopping and starting. If set to 2.0°C, the relay activates at Set Temp - 2°C (Heating mode). | 0.1°C – 15.0°C | | P2 | Delay Protection | Prevents rapid cycling of compressor/relay. (e.g., wait 3 minutes before restarting). | 0 – 10 Minutes | | P3 | High Alarm | Audible alarm triggers if temp exceeds this limit. | Off / Temp Value | | P4 | Low Alarm | Audible alarm triggers if temp drops below this limit. | Off / Temp Value | | P5 | Calibration | Corrects sensor reading errors. If actual temp is 25°C and display shows 24°C, set P5 to +1.0. | -5.0°C to +5.0°C | Over-discharge protection, Overcharge protection
Avoid running continuous loads right at the 10A limit to prevent the relay from overheating.