Write down the default master code (often found on a sticker inside the manual or on the back of the exterior assembly) before installing the lock. Once installed, changing this code is a manual priority.
Fingerprint (360° sensor), PIN code, RFID Card, and Mechanical Key.
All user programming is executed using the keypad. Ensure the door remains open during programming to avoid getting locked out during testing. zeus z3 digital lock manual work
Place your designated admin finger on the biometric scanner, or hold the admin RFID card against the card reader icon. Press the again to exit setup mode. ⚙️ Manual User Management Programming
Enter fingerprints, cards, or PINs as prompted by voice guidance. Locking Modes : You can manually switch between (locks after a set time) and Manual Lock (remains open until triggered). Integrated Sync System One of the Zeus Z-3's strongest selling points is its synchronized access Write down the default master code (often found
Even with proper manual work, issues arise. Here’s a troubleshooting table.
Disclaimer: This guide is for informational purposes. Zeus Z3 models may vary slightly by region or firmware version. Always refer to the original product manual for lock-specific diagrams. All user programming is executed using the keypad
The Zeus Z3 has adjustable settings that require manual input.